

| Subject: | Re: how engine oil degrades (was: sysnthetic oils) |
| From: | Will Wood |
| Date: | Thu, 02 Jan 1997 21:18:31 -0700 |
At 02:17 PM 1/2/97 -0600, cbennett@kpmg.com wrote: >Hi there, > >I have experience problems with my oil light and buzzer coming on while driving >my 86 Vanagon Syncro, and I've concluded that it was because I was using too >thin oil for the temperature outside. When I use 20-40 it rarely happens. > >But I am still wondering why are there two oil sensors, which I am told measure >too high as well as too low oil pressure on the engine. I can understand too low >pressure, but why would they want to warn the driver if the oil pressure is too >high? I never understood that. Can anyone explain it to me? > >Thanks, > >Charles > > An important thing to note is that when an engine wears, the clearances between the moving parts increases. Thus main and rod bearings allow more oil to escape, this reduces the effective oil pressure within the engine. When you're going at speed, the oil pump is providing enough pressure to keep the light/buzzer quiet. But if you were to use a gauge, you'd find that the pressure is really too low. Changing the oil provides a new viscosity level, which with oil age decreases and you have pressure problems again. Going to a higher viscosity oil, like 20-50 helps, but indicates that there is an age problem or other mechanical issue. One thing to note is that VW uses (since 71) a dual pressure system in all of the flat fours. I have seen the pressure pistons sieze up. When this happens, they can be stuck in the "relief" position which allows most of the pressurized oil to flow back into the crankcase instead of the main journals. Although this is rare, I have seen it happen which is why it's one of the good reasons to change your oil regularly. As to the too high question, there is a condition known as a blowout. This happens when the pressure entering the oil filter literally blows the filter up. I've seen it on Type IVs as well as Type I & IIs using a full flow system. The pressure coming off of a 30MM oil pump can be as much as 300PSI cold, which is why the dual relief system exists.
Have something to add on this topic today? Revive this thread in the forum »