

| Subject: | Re: Sliding Door, 86 Westy |
| From: | Leavitt |
| Date: | Thu, 20 Mar 1997 05:39:41 -0500 |
Blair Webster wrote:
>
> I don't want to convert my slider to a hinged model BUT I have a problem
> closing the darn thing, predominately in cold weather. It slides ok but will
> not latch properly (normally when the temp. is below freezing, of course).
> Just about lost the dog the other day going down the highway...
> I've cleaned and lubed the tracks and lathes but it doesn't seem to help
> that much. Does anyone have a solution to this problem?
It sounds to me like the gasket is the problem. The rubber can get
stiff in cold weather and cause the door to bounce back and/or not latch
fully. I find that the best way to make sure that it's fully closed it
to push on the left side near the hinge from the outside or pull the
right side when inside (my '81 has an extra handle there). You can
usually hear a solid click when you push there on a door that's not
closed fully. I'm not sure of any permanent way to make the door seat
better on the gasket other than to re-adjust it with the screws on the 3
hinges and 2 latches. It can either be a long involved process of trial
and error adjustments until it closes easily and is straight with the
chassis or it could be just a tiny hair off. Also make sure that the
gasket is tucked into it's channel all the way around.
Personally I'd like to replace my slider with a rear hatch type door
that swings upwards so I could have a super strong wind-proof awning
every time I opened the door! ;)
Noel
VOLKSWAGEN
_--````--_
/ _--````--_ \
/ / \ \ / / \ \
'81 Vanagon Westy | | \ \ \/ / / | | '68 Sunbug Autostick
| |\ \ )--( / /| |
(named Vana) | | \ \/ /\ \/ / | | (named Rachel)
\ \_\ / \ /_/ /
\ _``----``_ /
``----``
1937--1997Have something to add on this topic today? Revive this thread in the forum »