> Replacing a CV joint is pretty simple.  It requires a vice to put the axle
Unknown command - "REPLACING". Try HELP.

> in and something pop the clip off with
Unknown command - "IN". Try HELP.

> (special tool or screwdrivers).  To remove the CV joint you need to remove
Unknown command - "(SPECIAL". Try HELP.

> the whole axle that its
Unknown command - "THE". Try HELP.

> attached to.  You might need a Torx or stardrive internally wrenching tool
Unknown command - "ATTACHED". Try HELP.

> or
Unknown command - "OR". Try HELP.

> just an allen wrench (the other two are like an allen wrench but they have
Unknown command - "JUST". Try HELP.

> lots of points instead of being octagon shaped).  I would get a set that
Unknown command - "LOTS". Try HELP.

> can
Unknown command - "CAN". Try HELP.

> be driven by a rachet.  Then you loosen the bolts all the way around on
Unknown command - "BE". Try HELP.

All subsequent commands have been flushed.

Summary of resource utilization
-------------------------------
 CPU time:        0.016 sec
 Overhead CPU:    0.000 sec
 CPU model:         2x90MHz Pentium (72M)