Although the Vanagon dash in exceptionally easy to repair.......
                 MAN ARE YOU W r o n g!
  This is a case where a little knowledge is a dangerous thing.
  Learn about engines, then tackle the hard stuff. The dash of
  a car. It's filled with stuff: pumbing, wiring, wiper stuff, freon,
  pedel assemble, steering, duct work, cable to run stuff.

  I once took on a heater core in a 78 ford, ended up with
  the front seat out, the rear of the trans. dropped, and then
  resorted to cutting the dash sheet metal.
               GOOD LUCK!

            Eric                   86-VW4x4
            vw4x4@fyi.net          72-240z
            Pittsburgh, PA USA     1936-Chrysler

On Tue, 24 Feb 1998 nyquist@ACSU.BUFFALO.EDU wrote:

> Hello Folks,
> Looks like the blower motor for the heater/defroster on my '91GL is at
> death's door.  It was replaced once in 1993 at the dealer and I think part
> of the balance is STILL on my Visa bill.  I don't work on engines but
> taking apart a dashboard and messing with a few wires doesn't seem
> particualrly scarey.
> Any advice?
> Any diagrams available that will help?
>
> Thanks,
> John Nyquist
> nyquist@acsu.buffalo.edu
>