>
> Shouldnt be necessary but in order to remove mine I had to Remove my seat
> (lift small catch on the sliding hardware on the left hand side of the
> passenger seat and slide forward off of the tracks.) and swivel the seat 180
> degrees.  It seems the plate is not symetrical front to back, ie the swivel
> is offcenter towards the front.  if the seat were still on the base it would
> be facing rearward.  This should allow you to remove the two screws at the
> front.  If the seat wont swivel then after removing the seat try some spray
> lube (WD-40) or such and try again.  The  cover is not hinged it lifts off
> compleatly.  I just keep the two rear most screws in my cover(came that way
> from the PO) and it doesnt rattle or loosen.
>
Just a note, I've found I do not have to remove my seat (Westy with
swivel seats) to get to the battery.  As the seat is facing forward,
slide it back on its track.  Then swivel it 180 degrees so it is facing
rearward and you should easily be able to access the battery.

The swivel plate is indeed not symmetrical front to back.

--
Sean Bartnik
Fredericksburg, Virginia
1981 Volkswagen Vanagon L Westfalia
1974 Volkswagen Karmann Ghia convertible
http://www.type2.com/bartnik/myvan.htm
http://www.mwc.edu/~sbart7kb/vwbooks.htm