

| Subject: | Re: Loss of power |
| From: | Woodcock, Frank |
| Date: | Tue, 12 May 1998 09:36:42 +0100 |
> midworld midworld <midworld@HOTMAIL.COM> wrote
>Subject: Loss of power
>I got my van back from having the engine rebuilt and all is fine until <snip>
the van had a momentary lapse
>of power then fine.<snip> The engine has under aprox. 200 mile on it. does
anyone have an idea what might be happening?
>Thanks
>Cecil T
There are several causes of loss of power following an engine rebuild.
Here are some possible causes:-
* New piston rings which have not bedded in. They occasionally stick.
* Gunge ( grease, oil etc) fouling the sparkplugs - this can clear
itself after a long run
* Dirt in the carburetor - again this can clear on a long run with the
occasional 'foot to the floor'
Another cause could be a loose connection on the distributor or other
ignition part. Check that the wires are secure.
If the work was done by a garage - report the fault and get an
undertaking from them to repair if it has not disappeared by say 1000
miles.
I have all sorts of occasional misfires, clutch judder/slip with 'Pooh'
my 1981 Holdsworth Villa van. It goes top speed 55-60 mph which is slow
enough to enjoy the views. You can see 'Pooh' at my new website
http://www.users.globalnet.co.uk/~mpages/
Don't forget to change the oil after 300 miles. The engine will thank
you for it!
Good luck.Have something to add on this topic today? Revive this thread in the forum »