Dear listees,

    My overhead fan stopped working a couple of months back (I have never
bothered fixing the AC, the fan worked just fine).  I had it cranked up to 4
one day on a road trip and it just stopped all together so I wrote a letter
the list (a few  months back).  A couple of people told me that it might be
the "big" fuse in the rear side compartment and to check that out or its the
fan.....i.e. major pain in the neck.  So I just got around to it today and
found 20amp double fuse (to control each AC evaporator fan) in the rear side
compartment.  Both housings were partly melted enough so I can't remove the
yellow fuses.  When tried to take them out they just fell apart leaving the
fuses still in there.  So I took a pair of small needle nose pliers and tried
to get them out....nothing, they are melted and shot and just break apart when
i try and pry them out.  My questions to any and all:
1:Why did they partially melt the housings -rather- why are the housings
partially melted?
2: should I be worried as to why they were both partially melted (because I
have seen switches do this before due to a bad connector and I just replaced
them no problem), and if so then what?? - -or---
3: Can I just remove the old fuse housings from their wires and get a couple
of make shift 20amp fuses and housings from NAPA  (only parts store where I
am), or do I really need VW parts for this.
Any advice as always would be greatly appreciated!!
Thanks
PS:  If you have a Bentley manual the fuse I am refering to is on page 87.4,
Fuses S 51
Chris W.
87 Syncro GL