

| Subject: | Re: coolant temp send wire |
| From: | S_J_ WACKER |
| Date: | Mon, 29 Jun 1998 19:40:02 -0700 |
OK!!! I had been under the van, I had seen the "disk on a post", but I was looking for some kind of spade connector. Even tried to pull the wire to the back side of the thermostat housing just to see if it would reach if I did find a connector...wouldn't reach. Then, I remembered that when we removed the Cat, the wires I thought were disconnected, weren't and they were wire tied to the red/yellow wire. So when I tried to pull the O2 wire it pulled the r/y wire AND moved the whole mess of wire towards the rear of the engine compartment. Once I moved them forward again, and figured out how to connect to a "disk" it all made perfect sense. Went for a ride, temp works, LED stopped flashing after about a mile and the gas gauge finally got up to where it is supposed to be. I'm a Happy Camper!!!! Thanks to all for your help. Steve and Jo Ann Wacker San Marcos, Ca. 90 Carat 86 Syncro 86 Audi 5000 CS Quattro _____________________________________________________________________ You don't need to buy Internet access to use free Internet e-mail. Get completely free e-mail from Juno at http://www.juno.com Or call Juno at (800) 654-JUNO [654-5866]
Have something to add on this topic today? Revive this thread in the forum »