At 07:38 AM 7/27/98 -0500, Anthony Kimmons wrote:
>The other mistake could be that I used the old brown wire coming
>from the old sensor to connect to one of the new sensor tips.
>Should I have run a new wire for that? Do the wires have to be connected
>to a certain terminal on the sensor? I didn't see any markings on them,
>but will look again this afternoon.
>
Yes absolutely, the two senders are not identical and must be wired
correctly. Check the wiring diagram that should have come with the dual oil
pressure sender. Or just swap the two wires and see if that fixes your problem.

MM