I put a '81 vanagon engine w/F.I. in my '73 bus (formally had carb),
and have it *almost* running. I was very careful to follow out the wiring
schmatics in both the Hayne's manual for the '81 and the Bentley for the
'73, and am very sure I have the wiring hooked up right. If I turn on the
ignition and manually open the air sensor gate, the fuel pump runs as it
should.
   But, the car won't start. If I pull off the lead that goes to the coil
from the ECU (#1 terminal on ECU), the engine will actually start and run,
more or less. But putting that wire back on the coil and it won't fire up.
  Anybody got a clue on this.

 --
Harmon Seaver hseaver@harmon.bml.usouthal.edu http://harmon.bml.usouthal.edu
=======================================================================
All is impermanent, but this too shall pass away, and the way of the
Samurai is death -- so speak your mind now, or forever hold your peace.
=======================================================================
Copyright, Harmon F. Seaver, 1998. License to distribute this post is
available to Microsoft for US$1,000 per instance, or local equivalent.
=======================================================================