-------------------
Hi Kai,
    Ok I give up, what bosch book are you using that tells you to measure
afm voltage? I have even searched some old bus manuals, some  bosch
L-jetronic books but all my books mention using resistance to verify proper
operation of the afm. Thanks
Darrell

-----Original Message-----
From: Kay O Fremgen <kayfremgen@JUNO.COM>
To: vanagon@GERRY.VANAGON.COM <vanagon@GERRY.VANAGON.COM>
Date: Sunday, February 14, 1999 10:17 AM
Subject: hesitations (air flow meter)

>Hi Joe,
>
>There is not a lot that you have to know about this AFM. 1 The air vane
>(flap inside the meter) must open freely, smooth with on restrictions
>other then the spring tension. 2 on page 24.45 of the Bentley you will
>find the test for the AFM step 1 and 3 are clear. It is test 2 that I
>unclear. Bosch has a better way of testing this. Remove the black cap and
>connect a volt meter (analog meter it is easier to see the results) to
>pin 2 and 3 of the potentiometer (you will find the numbers if you unplug
>the 4 pin wire at the AFM) then plug the wire back in and turn the
>ignition on then slowly open the air vane it should start at 0.2-0.3
>volts and then slowly move to 4.5 Volts with on jumps.
>
>Good luck
>Kai
>
>___________________________________________________________________
>You don't need to buy Internet access to use free Internet e-mail.
>Get completely free e-mail from Juno at http://www.juno.com/getjuno.html
>or call Juno at (800) 654-JUNO [654-5866]
>