Dennis:

It's clear that I've been too timid about applying the heat.  I'll try
again tomorrow and be a little more aggresive.

Thanks.

On Wed, 24 Feb 1999, Dennis Haynes wrote:

> You need to heat it up to about 300 degrees.  I use a bearing heater but a
> torch will also do.  A good machine shop supply will have markers you can
> get that melt at different temperatures.  You don't wan to get he gear too
> hot as it can warp.
---------------------------------------------------------------------
Tom Young               young@sherlock.SIMS.Berkeley.EDU
Lafayette, CA  94549    '81 Vanagon
---------------------------------------------------------------------