> Hey guys I have myself in a Mess again.. I broke a Blue connector on my
> water Pump next to the little brass one.. its blue and its an electrical
> connection.. What is it? where can I get it and do you have any you can
> spare guys?!?! Please and thank you in advance!!
>
> Thank you very much!!
>
>  Jason & Laura Cornfeld
> 85 GL

It's the temperature sensor connector. If you broke the sensor
itself, you can get it at your flaps. If you broke the connector,
snip it off, and take it down to the flaps, they should (if they're
any good) have these in stock. Get a new rubber boot for it too. Then
install with either solder and heat shrink (don't neglect to twist
the wires together properly first), or use crimp on butt connectors.
Finally, before you push the connector on, put a bit of dielectric
grease on the terminals.

A couple of tips:

1.) The wires to the temp sensor are not polarized, i.e. you can swap them.
2.) If you need to get this thing going to run down to the flaps,
connect the temp sensor wires together, it'll be hard to start, but
should run ok once warmed up.

Joshua Van Tol -- jjvantol@uswest.net