Jason,

I had a F&F on my 1.9.  Also had a couple problems with it.
It was installed on the heater line about a foot toward the front of the
vehicle from the right head.  Had a rock fly up and break the cap on a dirt
road in the middle of nowhere.  Also, the main through tube warped from the
hot coolant coming off the head.  No longer round, but had a dip in it which
allowed coolant to escape.  Finally took it out just last month.

Karl Wolz

----- Original Message -----
From: Jason M. Yasment <jyasment@HOTMAIL.COM>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Tuesday, May 11, 1999 8:16 PM
Subject: Prestone Flush'n Fill Kit

> Fellow Vanageeks,
>
>     Has anyone else installed the Prestone Flush'n Fill Kit on a 1.9l
> vanagon?  If so, where?  If not, conceptually where is the best spot?
There
> are adapters for 1/2", 3/4" and 5/8" interior diameter hoses.
>
> TIA,
>
> Jason M. Yasment
> '84 Westfalia (up for new trans and brakes)
> '98 Jetta TDI (in the shop with US$3600 worth of rear end damage)
> '98 Ford Escort (rental car)
>