At 10:22 5/14/99 -0700, Aleksandr Milewski wrote:
>(right-front, #1 cyl?) were gone, and the gasket was halfway out. This was
>a bit of a surprise, since I'm used to a world where header bolts are
>removed with liquid wrench, cursing, and scraped knuckles, not mere
>vibration. ;)
>
>In any case, are these bolts in some way special, or do I just need to get
>a couple of grade 8.8 or whatever bolts? (stainless maybe?)

Hmmm.  If I had to guess, I'd guess you're in the market for some M8 x 1.25
Helicoils.  :(  The kit costs about $30 and comes with 12 Helicoils.  These
blocks are wicked soft, as we say hereabouts, and the torque values seem
very low to someone used to iron (me).  Try 21nm/14 lb-ft for M8
bolts.  Still looks ridiculous to me.  *Easy* to overtorque with a little
bitty ratchet.  And these are fair-size bolts.

d

David Beierl - dbeierl@ibm.net