> OK I just took the Ohm meter to my water level stick and when the
> float is at the top, I get no resistance (closed circuit), about 1 inch
> down I hear the click and the ohm meter reads about 250K as I
> move the float all the way down to within one inch of the bottom,
> then I get another click and the Ohm meter goes to 350K (nearly
> infinity - open circuit).  If that is of any help to anybody

Malcom, et al:

That pattern is similar to the readings I got as well.  David Beierl and I
have been corresponding off-line, and based on his apparently considerable
expertise in electronics, he has suggested that the LED panel is very
sensitive to the readings that the wand gives off, and that the wand has
gone outside of the normal spec due to age, etc.  He believes that the LED
panel can be modified by changing some resistors in order to make it more
tolerant of the varying impedance levels.  Another suggestion he made, which
I thought was a great idea, was to replace the existing LED's with brighter
versions so that they will be visible in daylight.

David, I'll let you add anything you feel is appropriate.

David or I will post a summary when we get the project sorted out.  in the
mean time, I am digging out my "solder sucker" and soldering iron, and
planning a trip to Radio Shack...  :-)

Brent Christensen
'89 Syncro Westy "Klaus"
'95 Cherokee Sport

----- Original Message -----
From: Malcolm Stebbins <Malcolm.Stebbins@MSVU.CA>
Sent: Friday, May 14, 1999 9:11 AM
Subject: Re: Source for water tank level sensor

> OK I just took the Ohm meter to my water level stick and when the
> float is at the top, I get no resistance (closed circuit), about 1 inch
> down I hear the click and the ohm meter reads about 250K as I
> move the float all the way down to within one inch of the bottom,
> then I get another click and the Ohm meter goes to 350K (nearly
> infinity - open circuit).  If that is of any help to anybody.
>
> I should add that my LEDs also do not read properly and I have
> taken the wand out of the van, I do not know if the wand or the
> LEDs are bad.   I'll try the Bentley 97.30 analysis.  Malcolm
>
> Kelly wrote:
>
> > At 10:15 5/13/99 -0400, David Beierl wrote:
> > >
> > >Hmmm...are you sure it's busted?  I have an '84 with electrodes in the
> > >side of the tank, so I haven't seen your setup -- but on mine the
yellow
> > >light means everything except "almost full" and "almost empty."
> >
> > Brent's description of how his water tank float and the LED indicators
are
> > malfuntioning sounds just like mine.  Mine did work properly until I did
a
> > thorough cleaning of my tank.  All the knocking around of the float rod
> > and it has never worked properly since. Gives me yellow virtually all of
> > the time.
>