I install a weekender bed, in my GL. Everything was a bolt in
except the pins that support the seat back. These pins are moved
I think forwards  about 3 inches. I could not believe that this
was done this way. I ended up removving the plates that were welded
into the doner, and welding them into my Van.
    I am under the impression  VW changed the width
of the sofa/bed, to accomidate the table side panel.

            Eric                   86-VW4x4
            vw4x4@fyi.net          72-240z
            Pittsburgh, PA USA     1936-Chrysler

On Wed, 26 May 1999, Morrell, Edward wrote:

> Does anyone have any experience with swapping out a GL with the interior
> from a Carat with the rear facing seats and flip up table.  Is this a big
> job?
>
> Ed
> 90 Carat 157k miles
>