I did this over the last 3 months, 3 times. Make sure your rebuild
is a good one. If you have an axle lock you must remove the 1/2 shaft.
You can get to the upper bolt from the engine compartment. the problem
comes in attaching the battery cable. There are 2 different lengths
of starters. They very by only 1/4" make sure you get the right one.

            Eric                   86-VW4x4
            vw4x4@fyi.net          72-240z
            Pittsburgh, PA USA     1936-Chrysler

On Wed, 26 May 1999, Nathaniel Merrill wrote:

> ANybody out there have any tips for the syncro starter install? For instance:
>  Do I really need to remove the axle/CV?
> How do you get to the upper bolt?
> What is the Sealer referred to in the Bentley,  could I use RTV silicone or something else?
> TIA
> Nat
> Seattle
>