You should have removed the 2 bolts the hold the servo in place.
Pull it out to extend the servo center shaft as if it was engaged.
this will give you just enough room to get around  the protective
cover, and find the roll pin. Be very careful with the servo.
The center shaft breaks easily.

            Eric                   86-VW4x4
            vw4x4@fyi.net          72-240z
            Pittsburgh, PA USA     1936-Chrysler

On Tue, 1 Jun 1999, Nathaniel Merrill wrote:

> Ok so My sign off did not work and I need help anyway!
> Can anyone pass along a few hints on how to "push back protective cover and push the split pin out"  to paraphrase  Bentley.  my protective cover is 1/8 th in thick and I could not manage to fold it back after a long struggle.  Also, after grabbing the edge with needle nose pliers, I pulled it up but could not locate any pin to push out.  AS I said any hints appreciated.
> TIA,
> PS- today is my last day at this e-dress. after that I'm off line...
> Nat
> Seattle
>