Hi Karl and All,
    The temperature 2 reading varies some with different sensors and
thermostats. I have never seen a properly operating one as high as 0.20
volts when warmed up.  I have never had a digitool installed and operating
below zero F either. I like your 0.12 volts, it is right in the ball park
with most. Temp 2 signal as well as all the other sensor  must be stable and
no jumping around excepting for the o2 sensor.     I have seen temp 2 as low
as 0.04 volts.  The key is to know your system and normal operating voltages
and one can pick up very slight anomalies.  Digifant and digijets have very
similar readings.
    I have been playing with the digitool on my 78 westy which has an 81 Cal
vanagon L-Jetronic system and it is very different on most voltage readings.
Darrell

----- Original Message -----
From: Karl F. Bloss <bloss@ENTER.NET>
To: <vanagon@GERRY.VANAGON.COM>
Sent: Thursday, June 17, 1999 3:00 PM
Subject: Re: Connector contact intermittant--Digitool to the rescue

> Your temp 2 reads .21V?  Is that normal operating temp for you?  Mine
> is about .12 - .17V.  .12 is achieve only when the van is hot and fan
> is cycling due to standing in traffic.
>
> Darrell, what do you usually read full warmed up?  Other Digitool
> users?
>
> -Karl
>
> Karl and Kristina Bloss, Trexlertown, PA
> '87 GL Weekender  "Beverley"
> Mechanic list: http://www.enter.net/~bloss/vw/vwshops
> Busses by the Trail - Oct 15-17, 1999: http://www.enter.net/~bloss/vw/bbtt
>