John:

You can remove these panels without screwing them up, if you're careful.
As I recall, there's one screw toward the rear of the panel that needs
to be removed first.  The panel is held on by plastic fasteners that can
be popped out of their holes in the door.  Use a putty knife, maybe one of
those plastic ones, to figure out where the fasteners are.  If you
carefully pry on the panel, right near a fastener, they will usually pop
out without damaging anything.

On Mon, 28 Jun 1999, Brush, John wrote:

> Has anyone had any experience with these panels that they could share, good
> or bad? I don't even see a way to remove them that won't ruin them, so any
> advice would be appreciated.

---------------------------------------------------------------------
Tom Young               young@sherlock.SIMS.Berkeley.EDU
Lafayette, CA  94549    '81 Vanagon
---------------------------------------------------------------------