I found a set of MSW 16 x 7 ET38 wheels from a 1988 Mercedes 300,
advertised in the local trader paper.  They have 17mm studs, so the bolt
holes need to be drilled out.  How difficult/expensive  is this?   I
measured the bolt pattern and it was difficult  to tell if it was 5 x
112mm.  Could they be 110mm?  How do I determine what size spacers I need
to run?
TIA
                                                            Tom Rehkugler

                       Arroyo Grande, CA 93420

___________________________________________________________________
Get the Internet just the way you want it.
Free software, free e-mail, and free Internet access for a month!
Try Juno Web: http://dl.www.juno.com/dynoget/tagj.