Tom, another "Learning" for your list:

One discovery that we made while installing the fuel lines and injector seals
was that we weren't getting a good seal at one of the injectors where it enters
the head. Some air would suck by the seal, the engine would hesitate, the leak
was lessen, the engine throbbed, more air sucked in and we had the makings of an
oscillating idle. When I applied a little hand pressure to the injector rail,
the sucking stopped and the idle was smooth. It turns out that the DPO had
dropped/lost/forgot the original 10 mm bolt for the injector "spectacles" so he
used a 3/8 instead. When straightened the spectacles and used a new 10 mm bolt,
the injector seals were snug and my idle is smooth (so far).

> And thanks to Coby who pointed out that the fuel pressure is checked by
> taking the screw and washer out of the four finger junction and clamping on
> some 7 mm tubing that has a pressure gauge at the other end.

That is neat. Now I know what the extra foot of 7 mm tubing is good for.

Larry