Depending on the sensitivity of the device it connects, you could just
splice the core and the shield(pull all the shield to one side of the wire)
separately, and wrap w/ heat shrink or electrical tape. However, if the
device is very sensitive, you could try using a BNC or cable TV shielded
connector to terminate each wire and then connect them. you will maintain
your EMI protection. Whatever you choose, definitely solder your
connections. Good luck!

-----Original Message-----
From: Markus Benne <mbenne@CROSSKEYS.COM>
To: vanagon@GERRY.VANAGON.COM <vanagon@GERRY.VANAGON.COM>
Date: Monday, September 27, 1999 13:44
Subject: Wiring Question

>Pardon the novice questions.
>
>I'm playing with my Subaru wiring loom.  I'm extending a wire which
>appears to be a wire within a wire, probably for shielding from EMI as
>the outside wire seems to connect to ground.
>
>Can someone tell me how to extend a wire like that (and where to get
>wire like that)?
>
>Also, when soldering a wire, how exactly should the wires be joined?
>Right now,
>I'm twisting the wires together, then folding the twist back on one side
>of the wire, then soldering that to hold it together.
>
>Thanks for any and all info.
>
>Without knowledge, but also without fear of failure(cause I fail a
>lot:-)
>...Markus
>