Use a chisel, it will come right out, but will destriol the bolt.
Just wait until you see how hard the rotors are to remove.

            Eric                   86-VW4x4
            vw4x4@fyi.net          72-240z
            Pittsburgh, PA USA     1936-Chrysler

On Fri, 19 Nov 1999, Bernie Heins wrote:

> I just picked up a set of new rotors for the syncro from Frisco Auto Parts ( Mississauga, ON ) for $65.00 CND each.( $43US) I got to the point of removing the small bolt holding the disc to the axle and ran into a snag.This darn bolt does not want to come out. Anyone have any experience with this? I'm thinking of heating up the area with a torch. Not an easy place to get into. I am afraid of worping the axle flange. Any ideas?
> Bernie
>