Larry;
        It will work IF the pulling force is applied to the inner race of
the CV joint. I had to adapt my gear puller to accomplish this. I
attached the arms to two piece of inch square stock bolted on either side
of the shaft behind the CV joint. The end of the axle has a dimple that
accepts the center screw of the puller.
Drive Safely & Good Luck
Ken Lewis<Kernersville,NC>86 VW crewcab;60 T-5 Coupe

On Thu, 25 Nov 1999 17:29:37 -0500 Lawrence Johnson
<larry_avery.johnson@SYMPATICO.CA> writes:
>I have heard that a wheel puller will do the job. Has anyone tried
>one?
>-Larry

___________________________________________________________________
Get the Internet just the way you want it.
Free software, free e-mail, and free Internet access for a month!
Try Juno Web: http://dl.www.juno.com/dynoget/tagj.