BTDT. I over tightened the sensor and ripped the head right off. Since I
was in B.F.Egypt on a Sunday I repaired it with JB Weld.  After about a
week the JB Weld absorbed the anti-freeze, became spongy and failed.
Drive Safely & Good Luck
Ken Lewis<Kernersville,NC>86 VW crewcab;60 T-5 Coupe

On Fri, 3 Dec 1999 22:30:05 -0800 Austin <austins@IX.NETCOM.COM> writes:
>1)  get a brand new sensor; turn it uppside down & swab out the cavity
>with
>alcohol + q-tips.  Fill the cavity with epoxy (JB Weld), let it cure &
>install per 2) below;
>

___________________________________________________________________
Why pay more to get Web access?
Try Juno for FREE -- then it's just $9.95/month if you act NOW!
Get your free software today: http://dl.www.juno.com/dynoget/tagj.